Roof1, Roof2, Roof3 - CatAdjuster.org - An Adjuster to Adjuster Community - Catastrophe Central, The Adjuster's Forum - Software

Roof1, Roof2, Roof3

Last Post 03 Sep 2007 01:22 AM by Jerry Stuart. 3 Replies.

Sort:

	Prev Next
You are not authorized to post a reply.

Author

Messages

Roy Cupps

CatAdjuster.org
Member

Member

Posts:359

01 Nov 2006 01:55 AM
Have you ever seen an Xactimate estimate that contains a refernce to Roof1, Roof2, Roof3 and so on? In most cases this is because the estimate writer is using the "Roof Icon" or the "f" key to add additions to their roof. I have added a tip in my blog to show you how to avoid this. You can find it here.

Adjuster Directory \| The Licensing Page \| The Cane Page

Jim Honer

New Forum User

Posts:4

02 Nov 2006 10:36 PM
You can also make it all one roof by highlighting them all in sketch and then right click, and choose "combine", the same way you would make a closet part of a bedroom. To each his own, but I understand what you mean by having multiple roofs in the tree. It makes you flip back and forth from the sketch if you are the reviewer. The only time it makes sense to leave it roof one, two, three is if they are of differing materials requiring different repair approaches or if they are actually on different elevations. Best Regards, Jim

It's not where we go, but what we do when we get there that defines who we are.

Roy Cupps

CatAdjuster.org
Member

Member

Posts:359

02 Nov 2006 10:54 PM
That's a good tip Jim. Thanks That's makes three ways to eliminate the multiple roofs. Is there a fourth method?

Adjuster Directory \| The Licensing Page \| The Cane Page

Jerry Stuart User is Offline

New Forum User

Posts:3

03 Sep 2007 01:22 AM
Select all roof then Ctrl+Shift+C

You are not authorized to post a reply.

Active Forums 4.1